恒溫恒濕機對安裝位置有哪些要求？

恒溫恒濕機對安裝位置有哪些要求？

1、為清潔及維修之用保留緊湊空間是非常重要的，一般要求恒溫恒濕機四周距離墻壁等障礙600mm以上；
1. It is very important to reserve compact space for cleaning and maintenance. It is generally required that the constant temperature and humidity machine can be more than 600mm away from walls and other obstacles.
2、為了防止恒溫恒濕機內部結霜，機組不應該暴露在溫度低于處理空氣露點的環境中，此外，如果機組安裝在室外，應適當采取防護措施，需要防止雪雨和霜的進入；
2. In order to prevent frost in the constant temperature and constant humidity machine, the unit should not be exposed to the environment where the temperature is lower than the air dew point. In addition, if the unit is installed outside, the protection measures should be taken properly, and the entry of snow and rain and frost should be prevented.
3、恒溫恒濕機安裝處應通風，應避開強電磁、油煙、風沙及灰塵較大的場所，且應遠離熱源、腐蝕性氣體，及存在或可能存在可燃性氣體、蒸汽與空氣混合行成的爆炸危險場所；
3, the installation of constant temperature and constant humidity machine should be ventilated, should avoid strong electromagnetic, oil smoke, wind sand and dust large place, and should be far away from heat source, corrosive gas, and exist or may exist or may be combustible gas, steam and air mixture of explosion dangerous place;
4、室外機組安裝處需要敞開空間，以保證室外冷凝器散熱良好。機組周圍應設有排水溝或管道，用于冷凝水的排除；
4. Outdoor unit installation needs open space to ensure good heat dissipation for outdoor condensers. Drainage ditch or piping should be installed around the unit to remove condensate.